What Electrodes Will Fit?

All of our electrodes will fit all American made Violet Wands and most European made wands.

Please note that you are responsible to know the size and origin of your device.

We Sell Only 7/16″ American Standard Size Electrodes Specifically for Violet Wands.

 While our violet wand electrodes may fit other devices calling for 7/16″, we will not guarantee fit for any but modern US made violet wands.

American standard size in violet wand electrodes was set at 7/16″ by the International Violet Wand Guild as it was and is the most commonly used and manufactured specification. 

There are many off brands and sizes made in small percentages.

Violet Wand Collets Hold Electrodes by Friction Grip. 

Never force electrodes in, just seat them till firm.  Forcing electrodes into the friction grip collet can splay the collet over time and require re-adjustment.

Our Electrodes Are Precision Manufactured With the Smallest Variation, Allowing Minimal Tolerances.

An incredibly low machine tolerance such as that 3/100ths of an inch is more applicable to the scientific industries, but we produce to these high standards.
If your collet has lost its tightness from use, or it was not factory adjusted properly, adjusting a collet back to spec is not difficult, and requires a small thin, flat bladed screwdriver.
 
Insert the thin blade of the screwdriver between the wall of the wand nose and one finger of collet (if a modern US made wand), or near the slot of the collet of an older or non-us made device. 
 
Flex inward approximately 1/2-1 full the thickness of a human hair and check for fit. 
 
Repeat if necessary.